Replacing the old cloth with new cloth of your choice on the bed and rails. We remove all of the old staples, ensure that the frame and the playing surface are level, the cushions are fully secured to the rails, and the seams between the slates are properly sealed with beeswax where needed. we offer full expert Pool Table Repair
This service may be needed if you are moving long-distance, installing new carpet or flooring, etc. The pool table is dismantled and all of the pieces are marked to guarantee that the table will be re-assembled correctly. The pool table is then stacked neatly in place to the customer’s satisfaction.
If you just moved into the area or purchased a new/used pool table and the table itself is in the room where it is to be installed, this is the service you are looking for. We position the table for optimum playability or to the customer’s specifications. We replace any worn or missing hardware and professionally assemble and level your pool table.
Pool table is disassembled at one location/residence. It is then carefully loaded and protected while being transported to the new location/residence. Once there, the table is completely assembled and is ready for play.*
We also service Hunterdon County Pool Tables and many other surrounding areas.
*We do not move 10′ pool tables or tables with 1 piece slate. If you have one of these types of tables, call us and we can refer you to someone who can provide this service for you.
In-House Moves: Minor Move
Pool table is put on dollies and moved from one room to another. This method is used only if the opening between rooms is wide enough for the table to fit through in one piece.
In-House Moves: Major Move
Pool table is disassembled and then moved to another room/floor and re-assembled for play.
Re-Leveling: Minor Leveling
Often re-leveling your pool table can be achieved by adjusting the legs (tables with leg levelers) or by adding/removing shims beneath the legs. This is all that is required if the playing surface is flat.
Re-Leveling: Major Leveling
If the level reading is different on all three pieces of slate, the rails and bed cloth need to be removed so that the slates can be adjusted to create a flat playing surface. In some cases, the slate may need to be removed also.
Each slate is crated separately in a custom frame according to its size using 1″x4″ lumber and screws.*
*This may be required by some moving companies.
The old cushions and cushion facings are removed and the rail facings are cleaned of all glue. New cushions are applied and allowed to set overnight (12 hours minimum) before the cloth is put on.
The service is normally done at the same time new cloth (recovery) is put on the pool table.